How To Make Bow Ties For Dogs

Download Article

Download Article

Bow ties are the superlative of debonair doggie fashion. Y'all can easily make your ain bow necktie for the canine in your life using scrap fabric and minimal sewing skills.

1. 1

   Measure your dog'due south neck. Gently wrap a soft tape measure around the base of your dog's neck, directly where its collar would normally sit. Slide two fingers beneath the tape measure and adjust the record as needed. Make a notation of this measurement.

   • Alternatively, you can measure the length of your canis familiaris's collar instead of the dog's neck as long as its collar fits well.
   • Dog neckband sizes range from extra minor through actress small, depending on cervix circumference:^[i]
     • Extra pocket-sized: 8 to 12 inches (20 to 30 cm)
     • Small-scale: 10 to 14 inches (25 to 36 cm)
     • Medium: 14 to 20 inches (36 to 51 cm)
     • Large: eighteen to 26 inches (46 to 66 cm)
     • Extra large: 22 to 30 inches (56 to 76 cm)

2. 2

   Cut a large rectangle for the bow trunk. The dimensions of this rectangle will need to vary depending on the size of the dog. You'll cease up folding this rectangle by its width, and so the final width of the bow tie will be about one-half the width of this initial rectangle.

   • For extra small and small dogs, cut out a iv-inch by 9-inch (x-cm by 23-cm) rectangle.
   • For medium dogs, cut out a 6-inch by xi-inch (fifteen-cm past 28-cm) rectangle.
   • For big and extra big dogs, cut out an viii-inch by xiv-inch (twenty-cm by 36-cm) rectangle.

   Advertisement

3. three

   Cut a smaller strip for the bow center. The size of this strip will too vary past the size of the dog. Its width should exist about 4 times the size of your desired finished width for the bow center, and its length should exist about the same size as the width of the bow body rectangle.

   • For extra small and modest dogs, cut out a two-inch past 4-inch (v-cm by 10-cm) strip.
   • For medium dogs, cut out a 3-inch past 6-inch (8-cm by 15-cm) strip.
   • For large and extra big dogs, cut out a 4-inch past eight-inch (10-cm by 20-cm) strip.

4. four

   Cut a long strip for the bow ring. Take the measured cervix circumference of your dog and add a seam allowance of 1 inch (two.five) to the length, plus another two to 3 inches (5 to viii cm) for flexibility. Vary the width of the strip by the size of the canis familiaris.

   • For extra pocket-sized and small dogs, make the strip ii inches (v cm) wide.
   • For medium dogs, make the strip 3 inches (8 cm) broad.
   • For large and extra large dogs, make the strip four inches (10 cm) wide.

Advertisement

1. 1

   Fold the bow body rectangle in half. Fold the bow body fabric in half crosswise, with the correct sides facing in and facing each other. Use an iron to press the folded edge flat.

   • Note that the width of the body should exist halved during this step, but the length should non be affected.
   • If desired, yous can pin the open edges together to assist concord them in place while you sew. This may non be necessary if the folded edge is securely pressed, yet.

2. 2

   Sew together forth two edges. Using a sewing car, stitch a straight stitch over the lengthwise edge of the body rectangle and along ane width/brusque edge, working with 1/2 inch (1.25 cm) seam allowance for each. Leave the other brusque edge open.

   • You can manus sew together the edges together, if desired, using a backstitch or similarly durable sew together.
   • If you don't want to utilise whatever sewing skills, you could utilize durable fabric glue. Note that the final bow tie won't exist as durable every bit a sewn version, though, and y'all'll need to await for the mucilage to dry before proceeding to the next step.

3. 3

   Turn the bow body right-side out and sew the final border. Pull the bow body through the remaining open edge, turning it completely correct-side out. Fold the open up border in past 1/2 inch (1.25 cm) effectually, then top stitch it airtight by automobile or by manus.

   • If the meridian stitching is very visible, consider adding a row of superlative stitching along the contrary width edge of the bow to rest out the appearance. Doing then is not strictly necessary, withal.
   • As before, you lot could perform the aforementioned pace using cloth mucilage for a no-stitch culling.

4. 4

   Press each edge. Iron the entire bow body flat, concentrating on the four edges.

   • This step is more than important than it may seem. If you don't press the edges flat at present, the bow necktie can bunch upward unevenly and won't await as sharp when placed around your dog'southward neck.
   • Temporarily set aside the bow body after pressing it.

5. 5

   Double-fold the bow middle strip. ^[2] Turn your attention to the bow center strip of cloth. With the right sides facing out, fold the lengthwise edges in toward the center of the strip. And so, fold the strip in one-half down its lengthwise center, hiding the raw edges inside the fold.

   • The length of the strip should exist unaffected, but the width should be reduced to a quarter of its original size.
   • Press the folded edges of the textile after making each fold to flatten the fabric and hold the folds in identify.

6. 6

   Peak stitch downwardly the long side. Machine sew or hand sew together down the lengthwise edge of the folded center strip, keeping the stitching as close to the open up border as possible.

   • You can utilize a straight automobile stitch for this, or opt for a more decorative top stitch if desired. Choose a durable backstitch or hidden top sew together if sewing the strip by manus.
   • Apply fabric gum to the open border for a no-sew together culling. Let the gum dry before standing.

7. 7

   Wrap the center effectually the trunk. ^[3] Return to the bow torso. Pinch the lengthwise center of the bow body together, so wrap the center strip around the pinched centre to agree it in place. Pin the center strip ends together behind the bow body.

   • You can vary the tightness of the compression by personal preference, but a tighter pinched center will create a more defined bow shape. As a general guideline, y'all should try to reduce the eye width of the bow trunk to about half of the original width.
   • Note that y'all may not need the entire length of the center strip. Simply wrap equally much of the strip as needed around the centre of the bow to concord it in place, and allow the backlog edges to hang off toward the back.

8. 8

   Sew together the center closed. Machine stitch or hand stitch the center strip together only behind the pinched body of the bow. Trim down any excess textile from the center strip to approximately ane/2 inch (1.25 cm).

   • Before stitching the middle closed, brand sure that you can fit one finger betwixt the bow center and the body of the bow. You'll demand to slide the bow onto the collar portion using this center strip, so at that place needs to be some extra space. For that reason, you should also avoid stitching the center strip to the body of the bow.

9. 9

   Plough the eye piece around. Carefully turn the bow center strip around the center of the bow trunk, continuing until the raw border of the eye strip is hidden beneath and facing the bow body.

   • Note that the seam edge of the center will be the dorsum of the bow and the smooth border will exist the front.
   • Set the finished bow aside until you're fix to assemble the collar.

Advertisement

1. 1

   Fold and press the brusk edges of the bow ring strip. ^[4] With the incorrect sides facing upwards, fold each curt/width edge of band strip in once. Use an iron to press the folds apartment.

   • Notation that each fold should only exist virtually 1/4 inch (half dozen mm). If you lot make the folds much larger than that, the final band may go also tight around your dog's neck.

2. 2

   Double-fold the bow ring strip lengthwise. Fold the long edges of the band strip in toward the centre until they nigh run into. So, fold the strip in half forth the same lengthwise middle, hiding the raw edges within.

   • Printing the folded edges afterward making each fold to hold them in place.
   • This pace should reduce the width of the band to a quarter of its original size.
   • Annotation that the folded width edges should as well be subconscious within this "tube" of material, as well.

3. 3

   Superlative stitch along the open edges. Using a machine or sewing by hand, meridian sew together the tube of fabric closed along the unabridged open length and both open widths.

   • Y'all can apply a direct sew, decorative stitch, or any other suitable top sew for this role of the projection. Similarly, you lot can besides use material glue for a no-sew culling.
   • Place the acme stitching as close to the open edges as possible.

4. 4

   Test the length. Wrap the band effectually your dog's neck. The ends should overlap by near 2 inches (5 cm), and you lot should be able to comfortably slide ii fingers in betwixt the band and your dog's neck.

5. 5

   Attach Velcro squares to either finish. ^[5] Place ane self-adhesive Velcro half to the superlative side of 1 terminate, then attach the other half of the Velcro to the bottom side of the opposite end.

   • Test the band again. When you wrap it around your dog'southward neck, both Velcro halves should meet and secure the band comfortably effectually your dog's neck. Reposition the Velcro as needed to go the right fit.
   • Y'all can also utilise sew-on Velcro instead of the cocky-agglutinative kind, or identify a few supportive rows of stitching forth the Velcro to give it added durability.

Advertisement

1. i

   Slide the bow tie over the band. Slip the center loop of the bow over the end of the band. Slide the bow downward the band until it rests at the eye point of the band.

   • Ideally, there should exist enough space between the center loop and the bow body for the bow tie to slide over the band without difficulty. If in that location isn't enough space, however, you could tie the bow tie onto the band using thread or ribbon.
   • If desired, you could stitch or mucilage the bow tie to the band to secure it. Leaving information technology loose gives yous the option to conform it after, though.

2. 2

   Put the bow tie on your dog. Wrap the finished bow tie collar effectually your canis familiaris's cervix and fasten it in identify using the Velcro. Bank check the fit again the make sure that it isn't too tight, then stand back and admire your work.

Advertisement

Add New Question

• Question

  Can I make one of these on a larger scale for myself?

  

  Of course. Yous tin can as well read Make a Bow Tie to observe a diverseness of ways to make i for you.

Ask a Question

200 characters left

Include your email accost to get a message when this question is answered.

Submit

Advertisement

• To salvage time and effort, consider attaching the bow tie to a store-bought collar instead of making your own band. Try to choose a collar that matches the neckband scheme of the bow tie.

Thanks for submitting a tip for review!

Advertisement

• This is non a durable collar, so you should not utilise it as a replacement for a normal collar or endeavor to attach it to a leash. If y'all want a bow necktie you can use with your canis familiaris'southward normal leash, brand the bow portion equally normal and slip it over a normal neckband instead of preparing the separate band.

Advertising

Things You lot'll Need

• Soft tape measure
• Fabric scissors
• one/2 yd (i/2 thousand) durable fabric
• Coordinating thread
• Atomic number 26
• Ironing board
• Sewing automobile
• Sewing needle
• Self-agglutinative Velcro
• Straight pins (optional)

Almost This Article

Article Summary X

To make a dog bow tie, measure out around the base of your dog's cervix and cut out a big rectangle of fabric that accommodates the measurement. Next, fold the fabric in half crosswise, with the right sides facing each other, and stitch along 2 of the edges. So, turn the fabric right side out before stitching the other edges closed. Finally, press the bow body flat with an fe, concentrating on the iv edges. To learn how to create the band and get together the remaining pieces, read on!

Did this summary help you?

Cheers to all authors for creating a page that has been read 51,340 times.

Did this commodity help yous?

Source: https://www.wikihow.com/Make-a-Dog-Bow-Tie

Posted by: glovergrater.blogspot.com

Share this post